Quality & Compliance

Client Satisfaction

We spare no effort to implement effectiveness of the quality management system (QMS). Our products are globally appreciated for its highest quality standards, which would have become a possibility due to the service-minded attitude of our competitive personnel. Besides, the highest levels of quality assurance are achieved by conducting rigorous pneumatic/gas test, pressure cycle test, and temperature and vibration test on each product.

Quality Policy

Pragati Metal Corporation continually improves the effectiveness of the quality management system (QMS) and sets quality objectives and work plans. Moreover, Weare committed to upgrading the capabilities of its technical and administrative staff through formal training and continuous technical quality awareness. We have achieved the high quality through the professional competence of the personnel, high working motivation, and a service minded attitude. Every single employee of Pragati Metal Corporation is responsible for the quality of his/her work. All our products are tested in accordance with internationally recognized standards or our own more stringent internal test procedures, which is developed considering the harsh field conditions.

In addition to this, we also offer specific testing to our client’s requirement.

• Raw Material Testing: All the material used for Manufacturing of fittings and other fabrication jobs are tested for chemical & mechanical properties. The Results are confirmed to meet the original material requirement before processing. We are using measuring equipment calibrated by Govt. approved calibration Agencies.
• Dimensional Inspection: All type of Flanges and fittings are checked for dimensional accuracy from raw material stage to in-process & final product delivery by using calibrated measuring instruments.
• Material Traceability: All the material used for Manufacturing of fittings, valves and other fabrication jobs are identified & fully traceable from raw material stage to final product.

Some special test on request of clients:

• Pneumatic/Gas test: All compressor and threaded fittings and valves are subjected to Pneumatic test at 150psi air pressure and 2000psi Nitrogen pressure. Pneumatic/Gas test is carried out after hydro testing and complete drying of the items following Hydro-Test.
• Helium Gas Test (HG-TEST) can be offered on request.
• Pressure cycle test: All fittings and valves are tested for pressure cycle test where pressure surges from Opsi to 5000psi. The test is conducted at the rate of 25 to 45 cycles per minute with the digital counter. The client can specify the number of cycles and condition of test.
• Temperature test on request: Fittings and vale are heated to the temperature up to 350oC for one complete cycle of 4 hours. After that valves are again subjected to Hydro, Pneumatic and Pressure cyclic test for no leakage. All the above test are certified by our own Quality control department and can be witnessed by client or third party inspection company of client’s choice.
• Vibration Test: Fittings and valves are tested for severe vibration under impulse pressure for no leakage